At-home dryer repair in Plovdiv
RotoRem Plovdiv repairs dryers directly at the customer's address, with on-site diagnostics and replacement of worn parts such as heaters and thermostats, without the appliance having to be transported to a workshop.
Diagnostics in Plovdiv - 25 €
Phone
089 834 0982Dryer diagnostics in Plovdiv
The team arrives at the address, inspects the dryer and checks the main components related to the fault described. Only after it is clear exactly what has to be repaired does the repair itself begin. The customer does not have to carry the dryer anywhere, and the diagnostics and the repair happen in one place, on the same day.
Besides dryer repair, RotoRem Plovdiv also provides washing machine repair at the address, with the same approach of diagnostics and repair in the customer's home.
Customer reviews
See what our customers say about our repair services
Ekaterina Dimitrova
June 12, 2026
I recommend RotoRem - Varna when you need repairs for dryers, washing machines, dishwashers, etc. I was impressed by the quick response, diagnostics, repairs, and attitude! They work very professionally and correctly!
Call to schedule your repair appointment
Dryer faults we repair
Most dryer calls in Plovdiv come from a few recurring problems:
Clothes stay damp after a full cycle
The programme finishes, but the laundry is wet or only partly dry. The most common cause is a blocked condenser or filter, which stops the air from circulating. The dampness can also come from a faulty humidity sensor that makes the programme stop too early. Cleaning the condenser often solves the problem, but if it is damaged or the dryer still does not dry, the whole system is checked.
The dryer does not heat
The drum turns, but the air inside stays cold. Possible causes are a burnt heater, a faulty thermostat or temperature sensor, and on heat-pump models a problem in the heat pump itself. Because the symptom is the same for different parts, the technician checks each of them before suggesting a replacement.
The drum does not turn
The programme starts and the motor can be heard, but the drum stays still. The most common cause is a broken or stretched belt. The rollers the drum rests on, and the motor itself, are also checked, because a worn roller can break a new belt as well.
The dryer stops during the cycle
The programme stops halfway or the dryer switches itself off. This is often the overheating protection, which trips when a filter or condenser is blocked. The cause can also be a sensor, the motor or the electronics. It matters to note when it stops and whether an error code appears.
The dryer does not collect or drain the water
The tank stays empty or water runs out of it. On condenser models the condensate pump, the hoses and the tank are checked. On models connected directly to the drain, the drain connection is checked as well.
The dryer is noisy or shows an error
Squeaking, rattling or humming usually comes from worn rollers, bearings or the belt. A foreign object left in a pocket can also make noise in the drum. The error code points the technician toward a particular system, but it is compared with the actual check of the appliance.
It smells of burning
That smell is a signal to switch the dryer off and not use it until it is checked. The most common cause is lint built up around the heater or a blocked air duct, but it can also be an overheated electrical component.
Each of these symptoms points to a different part, so on-site diagnostics before a repair is a necessary step, not a formality.
Dryer parts and systems we check and repair
A large share of dryer faults come from worn components that are replaced rather than partly repaired. Every replacement is done after the diagnosis is confirmed, so a component that is actually working is not replaced.
Heater
The air in the drum stays cold
Thermostat
Does not heat, or overheats and stops
Temperature sensor
Incorrect drying temperature
Humidity sensor
The programme stops too early or too late
Condenser
Clothes stay damp
Filter
Long drying, overheating protection trips
Fan
Weak airflow
Belt
The motor runs but the drum stays still
Rollers and bearings
Squeaking and noise while turning
Motor
The drum does not turn
Condensate pump
The tank does not fill or water leaks
Door lock
The programme does not start
Electronic module
Errors or the programme stops
Heat pump
Poor drying on heat-pump models
| Part or system | The problem it most often causes |
|---|---|
| Heater | The air in the drum stays cold |
| Thermostat | Does not heat, or overheats and stops |
| Temperature sensor | Incorrect drying temperature |
| Humidity sensor | The programme stops too early or too late |
| Condenser | Clothes stay damp |
| Filter | Long drying, overheating protection trips |
| Fan | Weak airflow |
| Belt | The motor runs but the drum stays still |
| Rollers and bearings | Squeaking and noise while turning |
| Motor | The drum does not turn |
| Condensate pump | The tank does not fill or water leaks |
| Door lock | The programme does not start |
| Electronic module | Errors or the programme stops |
| Heat pump | Poor drying on heat-pump models |
Not every fault means a part has to be replaced. The cause is often a dirty condenser or filter, so the decision to replace a part is made after the check.
Most often replaced parts: heater, temperature sensor, condensate pump, drum rollers and the roller of the motor that turns the drum, a problem in the electronic module, a full dryer clean, belt replacement
Belt, rollers and drum problems
When the drum does not turn or there is a loud mechanical noise, the parts that drive it are checked: the belt, the rollers, the bearings and the motor.
A broken belt stops the rotation completely, and worn rollers are usually noticed by squeaking. That is why, when a belt is replaced, the technician also checks the rollers, so the new belt does not break again.
After the repair the dryer is run on a programme to check that the drum turns normally and without noise.
Heat-pump dryer repair
Heat-pump dryers do not throw the warm air out. They return it to the drum, so they dry at a lower temperature and use less electricity. If they dry slowly, do not heat well or interrupt the programme, the cause can be the airflow, the sensors, the fan or the condensate system.
RotoRem diagnoses and repairs the accessible components. We do not repair compressors or the refrigeration system of the heat pump.
Dryer installation and removal
RotoRem installs and removes dryers in Plovdiv.
Installation includes positioning, levelling, a stability check, the space needed around the appliance and a test of the machine. On a suitable model a drain connection can also be made.
A dryer can also be installed on top of a washing machine when the conditions allow it. If the models need a stacking kit, the customer buys it in advance and we fit it.
When an appliance is replaced, we also remove and safely disconnect the old dryer.
Dryer repair prices in Plovdiv
Before work on the dryer begins, the customer is told exactly what is damaged and what is going to be replaced. That avoids a situation in which the fault turns out to be different from what was expected after the repair is already under way.
The prices are a guide for labour and do not include the cost of spare parts.
Diagnostics
25 €
The dryer will not start
from 20 €
The dryer does not drain water
from 26 €
The drum does not turn
from 31 €
Dryer installation
from 40 €
Washing machine + dryer installation (stacked)
from 65 €
| Service / problem | Price (EUR) |
|---|---|
| Diagnostics | 25 € |
| The dryer will not start | from 20 € |
| The dryer does not drain water | from 26 € |
| The drum does not turn | from 31 € |
| Dryer installation | from 40 € |
| Washing machine + dryer installation (stacked) | from 65 € |
Dryer brands we service
AEG, Bosch, Whirlpool, Beko, Indesit, Samsung, LG, Electrolux.
- AEG
- Bosch
- Whirlpool
- Beko
- Indesit
- Samsung
- LG
- Electrolux
Real dryer repairs in Plovdiv
Brand / model: BEKO
Problem: The dryer was not heating.
Area: Trakia, Plovdiv
Diagnostics: A fault was found in the temperature sensor
Repair: Replacement of the temperature sensor. After the repair the dryer heats and works normally.
Brand / model: BEKO
Problem: The dryer was not heating.
Area: Smirnenski, Plovdiv
Diagnostics: The heater was measured and found to be working, but the electronic board was not sending voltage to it.
Repair: The board was repaired. After the repair the dryer heats and works normally.
Brand / model: Bosch
Problem: The dryer was not drying the clothes because the drum was not turning.
Area: Hristo Smirnenski, Plovdiv
Diagnostics: The check found a broken belt and a worn roller on the motor that turns the drum.
Repair: The belt and the worn roller were replaced. After the repair the drum turns normally and the dryer works correctly.
How the repair works
You contact RotoRem and describe the problem.
We arrange a visit to the address in Plovdiv.
The technician carries out diagnostics.
You are told what the fault is and what the repair will be.
Repair and test of the dryer on site.
Dryer repair in different areas of Plovdiv
RotoRem provides an at-home service across Plovdiv and nearby. For addresses outside the city there is a surcharge of 2 € per kilometre.
Neighbourhoods we cover: Centre, Smirnenski, Karshiaka, Marasha, Kyuchuk Paris, Kamenitsa, Gagarin, Zaharna Fabrika, Filipovo, Proslav, Komatevo, Ostromila, Belomorski
The at-home dryer repair service is also available for customers in Varna, and in Sofia.
Frequently asked questions
Can the dryer be repaired at my address?
Yes, in your home in Plovdiv.
Why do the clothes come out damp?
Most often because of a blocked condenser or filter.
Why does the drum not turn?
The belt, the motor and the rollers are checked.
How much do diagnostics cost?
25 € in Plovdiv.
Do you install a dryer on top of a washing machine?
Yes, if the two appliances are compatible and can be fixed securely. The customer buys the stacking kit in advance.
Do you provide a warranty?
Yes, we provide a warranty for the repairs carried out. The terms and the length of the warranty are confirmed after diagnostics and before the repair starts.